I’m printing these small bins for a advent calendar and seeing that some of the bins have these squiggly bits on the inside. They’re wildly inconsistent. You can see this bin doesn’t have them until a certain height and other bins that printed at the same time have them at different heights. Happening across different filaments. I ran a calibration cycle because I hadn’t lubed and calibrated in a while, but it’s still happening.

Any thoughts on what else I should be looking at?

Edit: Forgot to mention I’m printing on a Bambu Lab A1 (sorry got it before they went mad)

  • TDCN@feddit.dk
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 hour ago

    Wet filament can easily cause this. If the spool is not evenly dry sections filament can be more moist than other especially on small prints.

  • ThePantser@sh.itjust.works
    link
    fedilink
    English
    arrow-up
    2
    ·
    3 hours ago

    Those are retraction blobs. It means the filament is oozing when it travels from one side to the other. I am not a Bambi user so idk what the setting is called but I would adjust the retraction length slightly more.

    • Natanox@discuss.tchncs.de
      link
      fedilink
      English
      arrow-up
      1
      ·
      33 minutes ago

      That and/or travel speed. Modern printers largely avoid these issues due to their ridiculous acceleration and velocity. I always make sure those values are cranked all the way up for head travel.

      On older printers, especially 12V bowden style ones, these artifacts were basically a given on larger prints.