vladmech@lemmy.world to 3DPrinting@lemmy.worldEnglish · 7 months agoMy CR-10's had a good run but I made a slight upgrade todaylemmy.worldimagemessage-square10fedilinkarrow-up144arrow-down11
arrow-up143arrow-down1imageMy CR-10's had a good run but I made a slight upgrade todaylemmy.worldvladmech@lemmy.world to 3DPrinting@lemmy.worldEnglish · 7 months agomessage-square10fedilink
minus-squarevladmech@lemmy.worldOPlinkfedilinkEnglisharrow-up3·7 months agoGot it set up and printed a little trinket I’d made for my wife earlier, that on the CR-10 printed in about 27 minutes; took a flat 13 on the K1 and that was with a very conservative 7500 mm/min. I’m excited to see what this can push up to!
Got it set up and printed a little trinket I’d made for my wife earlier, that on the CR-10 printed in about 27 minutes; took a flat 13 on the K1 and that was with a very conservative 7500 mm/min. I’m excited to see what this can push up to!