cross-posted from: https://lemmy.world/post/5265624

I made this about a year ago and it’s one of my favorite creations. Even though I made a mistake in measuring the bottom and had to cut out some slots. One day I’ll print it again, but it used a ton of filament and took forever last time.

  • seathru@lemm.ee
    link
    fedilink
    English
    arrow-up
    4
    ·
    1 year ago

    Old article but I’m sure the science hasn’t changed: https://hackaday.com/2016/02/01/3d-printing-fumes-new-science/

    Basically, if you are printing with PLA you are probably pretty safe. But I still don’t think I would sit in a tiny closet and hotbox with my printer. An open window or carbon filters on your HVAC are probably more than sufficient. And PLA is the most popular type of filament, so you aren’t limited much there. Unless you need higher temperature parts to withstand sun or car interiors. Then you are getting into materials you want to start looking into better ventilation for.

    • canthidium@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      3
      ·
      1 year ago

      Yeah, I mostly print PLA, and occasional PETG. My printers are in enclosures as well and while I don’t have any dedicated ventellation system, they are by a window that has a fan blowing outside. I’m not too worried about it.

    • Fogle@lemmy.ca
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      Even that, I’ve got a center console organizer in my car made of pla and it hasn’t deformed at all. So as long as it’s not in the direct sunlight