After my last printer broke, I am considering getting this one for it's high precision, vibration stabilisation, and other good features, but wanted to check your experience with it before going ahead.
After my last printer broke, I am considering getting this one for it's high precision, vibration stabilisation, and other good features, but wanted to check your experience with it before going ahead.
So lets start from the top:
All printers have the same precision.
I guess you're talking about input shaping, which reduces artifacts and shaking of the printer (a little)
Most budget printers right now have lots of the same creature comforts that this printer has.
Right now the biggest things are community/aftermarket support (moddability), price and firmware. You should get Klipper to get input shaping, so that narrows it down. Look for some klipper printers (e.g. Sovol sv07) and decide which one you like best. They are almost all the same, save for qc and qa issues by some companies and sometimes lackluster support. Any printer can produce awesome prints. It's only a question of how much time you have to fiddle with the settings. Cheers!
All printers have the same precision? I thought it was the degree to which the filament may vary from the specified location and is measured in mm, like some are 0.1mm, some are 0.05mm, some are 0.2mm, etc?
All printers use the same components. Same motors, leadscrews and belts. If the printer is built well, the precision will be the same. You obviously have play in some machines, but due to the variance in filament it can vary from negligible to basically nonexistent. It's not the machines fault most of the time. Polymers have variance and sometimes unpredictable behaviour. Just part of the game.
From your recommendation, I'm leaning towards the Sovul printer. What has been your experience with it, like ease of use, proneness to breakages, or anything else unexpected from the Amazon page?
So I have used the sv06 and had a bit of a run in with the sv07. Both are decent machines with their own quirks. The sv06 needs bearings replaced after 3 months of use at the latest, after that runs perfectly. The sv07 uses v-wheels, and is therefore lower maintenance. They both use the same toolhead design and both print well enough. sv07 is a bit more finnicky with cooling (special klipper command for the big fan) but they are both decent machines. I personally run a heavily modified Ender 3 v2, but currently, the Sovols are some of the best bang for the buck. Right now, I would buy the sv06, change the bearings from day one and that's it. It is basically a 1:1 copy of a Prusa, and printing replacement parts for it is extremely easy, if anything ever breaks. The only thing it "lacks" is a filament sensor (haven't had the need for one in the time I have been printing), but that is easily added. Do your own research though. Lost in Tech has some great reviews on both machines.
The SV07 (just now) the firmware almost immediately broke after I put it together, powered it on, started it autoleveleling and the stopped it because it was screeching, and the rebooted it. Now it won't power on without showing green text, or doesn't progress past the loading screen, or doesn't turn on at all. It's different every time.
What country are you located in?
Uk. The firmware suddenly resolved itself, but now the y axis (the bed) doesn't seem to be moving properly, it tries to move off where it can't, and says 'out of range' to moving where it can.
Just in case, check the PSU Voltage. Check the plugs on the Y axis motor. Worst case, you might need to redownload the CFG file for your printer. Try that. Write again if none of that works.