What kind of filament are you using? I’ve had that trouble with ABS before and what worked for me was making a slurry of acetone and some scrap filament and painting it on the glass then adding a brim to the model in the slicer. With other filaments, it’s always been playing with the temps and using a brim in my experience.

I loved Hudson Hawk. The story was bonkers, the musical numbers were entertaining and had a great ending.

I’ve used the torch and cold pull methods successfully, but have had great luck with a cheap set of acupuncture needles from Amazon. I would pre-heat on the printer and just poke the needle in there a bit and feed filament through.