You should consider opnsense instead of pfsense in any case.
You should consider opnsense instead of pfsense in any case.
What are you using for a drive controller?
Even the slowest SSD write speeds should be faster than an HDD, and those have been running systems perfectly fine for decades. I’ve never used enterprise SSDs (usually one little consumer SSD, or even USB, for boot/cache and a bunch of HDDs for storage) and I’ve never had a problem.
What kind of hardware are you using?
Why separate it? It’s part of the same stack. Radar downloads, Jellyfin plays.
Ebay. If you’re outside the US, you’ll probably be better off with a more local site.
I usually find the cheapest drives and buy multiple of those, but you should be able to assemble a RAID out of different disks, though you’ll be limited to the space of the smallest one in the mirror set.
Also make sure that your RAID systems supports this.
This is what I do, but with alma instead of debian.
Proxmox can run containers directly, but I haven’t tried it yet.
What exactly is not working? What is it doing/not doing, compared to what you are expecting it to do?
Well, if you’re doing static assignments because there’s no DHCP, then it makes sense to not use the DHCP range.
I would consult the documentation for what exactly it means by a request for “next available IP”.
I feel like if you want addresses assigned from DHCP, just use DHCP.
PDQ Deploy is pretty highly recommended.
Hmm. I’m not sure what the advantage would be over just creating communities on existing instances, then, if someone else is still going to be the admin.
Sure. What’s your plan for moderating content like piracy, death threats, CSAM, and terrorism?
Just ping it?
Actual traffic might be slightly different, but honestly on a LAN you shouldn’t need to worry about latency. But you’re not going to be able to run iperf3 on that router in any case.
Use the -arr tools for organizing/renaming/tagging, and Plex or Jellyfin for playing. You don’t need to connect them to any downloader.
Huh. Kind of surprised it supports up to four drives, but if that’s what it says, there you go. Shouldn’t be any risk of drawing too much current through the wire. At most the board or PSU would shut down.
Also, if you are putting more drives in, see if the BIOS lets you enable staggered spin-up, so that they aren’t all peaking at the same time.
If that’s the stock part, seems like it would be within spec. You can check the manual or detailed spec doc to be sure.
A more modern processor probably has better power efficiency. But this one should support features like turning off some of the cores or throttling down when not needed.
You could also see if you can get one with lower power consumption, like even the 6700T.
Right, a bit flip in ZFS cache shouldn’t cause that. But a bit flip in active memory could.
Anything in the Jellyfin logs?