Really? I thought they were free and didn’t affect bandwidth.

Ah ok I’ll look into that then as long as I can put it on thick that should work.

Is that moldable?

Ah thanks for the input…I didn’t think about all spools spinning the samed until you mentioned it so I just decided to print the individual rings that I would put the bearings in then I’m gonna put them on a metal rod.

I have silica packets

Here is what I was thinking https://www.thingiverse.com/thing:2494109

But not sure if it would work

For my first dry box I’m currently using a 1.5 diameter PVC with 8 spools I haven’t noticed any sagging (should I upgrade to a bigger PVC pipe though just in case?)

I just don’t trust it as much as I thought and don’t want as many holes which is why I was wondering if I could place the filament for muy second dry box on like two PVC pipes and have them be used as a roller

So I should be fine if my charger ranges from 19-24V? Or does it need to only be 24v?

Not sure how familiar you are with electronic stuff, but the fans I have are 24v and 0.1A my laptop charger outputs up to 6A that shouldn't be an issue right?

Seems complicated I might just connect it to and adapter I can plug my 24v laptop charger into or just getting a buck converter

Like I said in my other comment

would it just be better for me to use one of these https://www.amazon.com/gp/product/B07C61434H/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 with a laptop charger?

Idk what type of connector my printer uses since my fan is different

How about a raspberry pi?

Would that still cause a fire?

Would I connect both positive and negative to it?

Also would it just be better for me to use one of these https://www.amazon.com/gp/product/B07C61434H/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 with a laptop charger?