We created the world of monorail 1. Everything exists to bring more people to monorail 1. What is monorail 1? It is a 4 car monorail that takes the shortest possible path back to the start of the station. We have several other attractions at the park such as: The Pit; Memento Mori; Install CSS, but none of them are the main attraction.

Started playing openrct2 multiplayer with a friend yesterday. Some of the best fun I’ve had.

I thought the same thing for awhile!

It might break the roof. Those straps are nearly as wide as that truck’s brake lights, i don’t see them snapping so easily.

Sorry, it’s a reference to this video https://youtu.be/Ja5BDtMybBA

But he didn’t, there was no point. There was another player named AntiBubzia on the other world doing the exact same thing backwards to cancel out Bubzia’s completed run every freaking time.

Wow, this is an incredible guide thanks for showing me

I figured there might be something like this that i hadn’t seen. I’ll look into it tomorrow, i get the feeling this would cause the inconsistency.

I have never bought an ender. I just happen to have one :P

Ah, thank you for the advice and the link!

The falling prints i think have issues in the same spots, there are relatively small patches around the print surface that don’t print very well, though they don’t seem to correspond to the bed leveling screws or anything. Now that i say that I’ll have to check that I’m using the mesh level correctly when i get home.

I’m still using a Bowden type extruder. The extruder itself is a generic aluminum one. My filament is run out of a sunlu dryer by the side of the machine.

I think i actually raised the jerk at one point to reduce the radius on corners, so i can bring that back down again and experiment with acceleration.

I have a glass bed and I’m using the tramming function with the mriscoc firmware to give me depth readings for each of the four screws, and I usually reign them in to about 0.04mm range. Parts close to each other tend to have similar but not the same results, and i think the patches are too small to be from bed leveling, usually only a couple centimeters.

I can redo esteps, i can see what you mean about the overextrusion. I only set my esteps to the number recommended by the manufacturer of my extruder, but i haven’t measured it myself yet, maybe that’s a bit silly of me. Though if that’s the problem then I’m still curious why it’s different in different areas.

I can check out acceleration too, i looked up what acceleration and jerk meant at one point but it didn’t make much sense to me at the time.

Dragged

I’d guess both are made of cells with lots of keratin in them, though i am making this up as i go.

Well now i feel worse /j

Especially if it has widespread knowledge and downloads.

There’s no countries in the EU? 😢

If only i knew the truths 😞

How to pay taxes to a country you don’t live in

At some point I’m just going to start donating to the EU