Hell, with modern stepper motors and extruded aluminum box frame, you don’t even need a 3D printer to build a 3D printer. It would certainly make it easier, but it’s not required. You could manufacture an entire 3D printer using off-the-shelf parts and a raspberry pi (or maybe even an Arduino) to control the motors. It wouldn’t be elegant, and it would require a lot of calibration… But it would be doable if someone were so inclined.
I suppose my old Prusa just jumped a bit in value.
You can use a 3d printer to build a 3d printer. When they figure that out, will they try to stop those parts from being printed too?
Who did they consult on this, and did that person or persons purposely lead them astray, or were the consultants equally ignorant?
Hell, with modern stepper motors and extruded aluminum box frame, you don’t even need a 3D printer to build a 3D printer. It would certainly make it easier, but it’s not required. You could manufacture an entire 3D printer using off-the-shelf parts and a raspberry pi (or maybe even an Arduino) to control the motors. It wouldn’t be elegant, and it would require a lot of calibration… But it would be doable if someone were so inclined.
Wait to see that they discover that you don’t need a 3d printer to build a 3d printer…