I’m curious if anyone uses sandblasting for cleaning up their prints. If not, what’s your favorite way to clean them up?

    • FuglyDuck@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      The ones I’m seeing are like 60-500, no way my parents would have dropped that for a toy. (Specifically one that lasted of 2 weeks,)

      • exploding_whale@lemmy.ml
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        Aside from that one tiny cheap toy in the sears catalog backnin the day, my recollection was starting price was around $250 for any tumbler(dad was considering them for years is the only reason I have any recollection). The $52 Harbor freight option is an impressive deal especially considering a few decades of inflation. I’m not say they were ever affordable toys, just that they are more affordable than they used to be. Size is a pretty big limitation on most readily available ones below the $500 mark.

        • FuglyDuck@lemmy.world
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          Yeah… it probably was thebsears toy.

          That said the only part that would likely wear is the drum, which, if you can print one, you can print more, heh.

          • exploding_whale@lemmy.ml
            link
            fedilink
            English
            arrow-up
            1
            ·
            1 year ago

            I think print one and apply a castable coating like urethane or maybe plastigip to the inside could be pretty long lasting.

            • FuglyDuck@lemmy.world
              link
              fedilink
              English
              arrow-up
              1
              ·
              1 year ago

              It’s a cost vs reward thing… so take this with a grain of skepticism, but, if durability was the sole consideration, nylon filament might give the most. nylon is very slippery so it’s unlikely to abrade as fast. (this is why it’s used in plastic gears.)

              • exploding_whale@lemmy.ml
                link
                fedilink
                English
                arrow-up
                1
                ·
                1 year ago

                I think nylon does well with sliding friction, but have some concerns about whether it would hold up well to the kind of sharp edges you tend to have with abrasive media. That’s from some observation on both commercial rock tumblers, industrial ball mills, and abrasive blasting equipment. I won’t say I know enough from experience to say it will work for sure though.

                • FuglyDuck@lemmy.world
                  link
                  fedilink
                  English
                  arrow-up
                  1
                  ·
                  1 year ago

                  won’t say I know enough from experience to say it will work for sure though. there’s “working” and then there’s optimal. lol. pretty sure you could drop some media in a martini mixer and hand it over to sugar-crazed kiddies and have it “work”. I accept no responsibility for that inevitable disaster,

                  that said, I suspect that depends on the kind of media used. sandy grit in a water solution or something would probably be fine.

                  • exploding_whale@lemmy.ml
                    link
                    fedilink
                    English
                    arrow-up
                    1
                    ·
                    edit-2
                    1 year ago

                    Now that you mentioned it, I have a toddler and a cocktail shaker already. I’ll slap some ducktape on the lid and hope to contain some disaster.