This seems to be a bug in the slicer. I’m seeing the same issue in OrcaSlicer if the skirt height is set to more than one layer (even if the skirt is disabled). This makes sense if a skirt is used (can’t print a continuous spiral if you have to switch between printing the object and the skirt), but not if it’s disabled.
What slicer are you using? If it’s a PrusaSlicer fork, this is likely the same bug.
Klar hinterlässt das Spuren, aber nichts was man mit etwas Seife oder Spüli nicht wieder weg kriegt. Der Dreck ist ja in dem Moment schon gelöst (sonst wäre er noch am Fahrrad). Nur Festtrocknen würde ich es nicht lassen.
Ich wäre nur vorsichtig dabei, mit höherem Druck direkt an die Lager ran zu gehen. Danach hast du sonst auch Wasser in den Lagern und musst doch alles auseinander bauen und neu fetten.
My router is called Jupiter, everything connected to it is named after a moon. Callisto, Ganymede, Thelxinoe, Kallichore are what I’m currently using.
IIRC, this is actually done at some point in the books.
You can host a Firefox sync server yourself. You could run that on something like a Raspberry Pi in your local network. If you need remote access, use something like cloudflare tunnels (although I guess that’s something else to be paranoid about).
That’s why I don’t let every device decide individually. I know my router (FritzBox) prioritizes the pi-hole (it’s even called “preferred” and “alternative” DNS-Server in the UI)
I have my pi-hole setup as the upstream DNS in my router, with cloudflare as a secondary DNS. That way, all my devices always use the router for DNS (since that’s what is advertised in my DHCP) and the router then uses pi-hole if it’s available, or cloudflare if it isn’t. But the individual device doesn’t get to choose between different servers.
The part is just pretty small, I have the EW set to 0.45 mm withe 0.4 nozzle. But I will try turning it down further.
The rounding looks much more extreme than what I would expect or have seen on other printers I worked with (mostly Ultimakers).
I’m guessing it’s about documenting the assembly of safety-critical components. If some part of, let’s say an airplane fails because a bolt comes loose, the manufacturer wants to have a paper trail attached to it to prove that this specific bolt was indeed torqued to the correct spec. Connecting the wrench to the network could make this documentation much easier.
You can try to disable software End-Stops with this gcode:
M211 S0
Be aware though, if you do that, there is nothing preventing your printer from trying to move beyond the hardware limits and possibly destroying itself. You can enable the end-stops again with:
M211 S1
Solvespace might be exactly what you’re looking for. It is FOSS and works well for simple models. Some functionality is missing though, for example chamfers and fillets.
Alles trägt zum Klimawandel bei, die Frage ist nur wie viel. Ich fände eine einheitliche Kennzeichnung, wie groß die Auswirkung ist, sinnvoller - so ähnlich wie der Nutri-Score.
Das hätte eine tatsächliche Informations-Funktion statt dieser generellen Schuldzuweisung ("Alle Fleischesser sind böse"), die wahrscheinlich nur begrenzt effektiv wäre.
HiPER Calc Pro. A great scientific calculator I use constantly. (There is also a unpaid, ad-supported version, and the ads weren’t too intrusive the last time I tried it)