• ilinamorato@lemmy.world
    link
    fedilink
    English
    arrow-up
    5
    ·
    edit-2
    2 hours ago

    This happened to me with Chamberlain, too. MyQ is malware at this point. I went with Meross, though.

  • Bell@lemmy.world
    link
    fedilink
    English
    arrow-up
    6
    ·
    4 hours ago

    I have two garage doors so built my own controller with an esp32, esphome and home assistant. Very easy for the basic functionality. I added magnetic sensors to tell when the doors were closed. Then I added a temperature sensor for fun and some buttons to trigger HA for other outside devices.

    Been done a zillion times by others I know.

  • reddig33@lemmy.world
    link
    fedilink
    English
    arrow-up
    5
    ·
    4 hours ago

    I ditched Chamberlain because they did not work with Matter or HomeKit. Ended up buying a Meross adapter that works great.

  • dmtalon@infosec.pub
    link
    fedilink
    English
    arrow-up
    1
    ·
    4 hours ago

    Mine went up with the house in 2009 and are not Smart. I bought a “smart” device to smrtin up my garage doors, where the instructions said to just connect where the inside button does and it’s internal relay to trigger the door

    Unfortunately my doors were kinda smart. The button in my garage has a motion sensor on the wall switch that triggers the overhead light, but it still uses just two wires to connect to the controller. They are still simple contact switches to open/close, but they carry some voltage/data across the line and that was preventing the smart controller relay from being able to close the circuit.

    I ended up making a standard 12vdc car relay dongle to overcome this voltage on the line.

    Now, home assistant triggers the smart device, which triggers my little relay to make the connection and boom, bobs your uncle.

    • Bell@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      58 minutes ago

      One of my doors had this “not a dry contact” problem. I opened up the wall switch for it and soldered wires onto that internal switch, then ran those to my controller.

    • ilinamorato@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      ·
      3 hours ago

      Sure, but then you don’t get the notification when you leave your garage door open, which is basically 100% of why I have the app in the first place.

      • ryan213@lemmy.ca
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 hour ago

        Ah, makes sense. I just have mine auto-close at a certain time, but I don’t even care if it closes or not. Lol

    • partial_accumen@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      ·
      3 hours ago

      I would think that the important notifications that OP wants of “your garage door is open” would also be blocked.